bargainposa.blogg.se

Note: Nox is defaulted to start in tablet mode, you could choose in System Settings > Advanced > Startup Setting > Phone to better emulate the Android phone experienceĤ. It could also be connected to intellij idea and eclipse as well.ġ. Download and install the latest version of Nox App Player from our official website: Ģ. Start Android studio and create a new activityģ. Start Nox App Player, go to Nox system settings > turn root mode on > save changes and restart Nox This post will give a step by step guidance on how to connect Nox with Android Studio as an example. Nox App Player is a full feature Android emulator which could be used for Android development, testing and debugging. If your Android device is not correctly detected by RAD Studio or the system Device Manager, follow the steps above to verify that USB debugging is enabled.įor general information about development setup for Android devices, see the Android documentation.How to connect Android Studio with Nox App Player for Android development and debug If you accidentally click Cancel, disconnect your device from your PC and connect it back to make the dialog show up again on your device. If you are running Android 4.2.2 or later, you may see the following dialog when you connect your device to your PC running RAD Studio:Ĭlick OK to allow USB debugging on your PC. For more information, see the Amazon documentation. Select Settings > Security and set Enable ADB to On. Tip: You might also want to enable the Stay awake option, to prevent your Android device from sleeping while plugged into the USB port.įor more information, see Unlocking Jelly Bean and Higher Devices

Tap the Build number seven times to make Settings > Developer options available.On the device, go to Settings > About.The steps to enable USB debugging depend on the version of Android running on the target device, as indicated in the following table:Įnable the USB Debugging option under Settings > Developer options.įor Android 4.2 and newer, Developer options is hidden by default use the following steps: